Northern Colorado · Weld County
Frederick epoxy floors.
Frederick's newer homes and shops are an easy run down I-25 from our Fort Collins base. Full-flake, metallic, quartz and solid-color coatings for garages, shops, basements and businesses in Frederick, every one starting with diamond-ground prep.
- Free on-site estimates
- Diamond-ground prep
- Northern Colorado & Denver
- Garages · Shops · Commercial
01Garages in Frederick
What Frederick floors look like.
Frederick has added a lot of newer neighborhoods along the I-25 corridor, and most of those homes have attached two- or three-car garages that are still bare concrete. There's also an older town center with smaller homes and older slabs.
Newer Frederick garages usually need very little repair, so the job is mostly grinding, coating and picking the look. Older floors get crack and pit repair first.
Whatever the floor, the job looks the same: we diamond-grind the slab, repair cracks and pits, put down a base coat, broadcast flake or quartz (or pour metallic), and seal it with a clear topcoat. No acid etching, no roll-on kits.
02Why coat it
Built for Frederick winters.
Frederick commuters drive a lot of treated highway in the winter, and the slush that comes home on the car sits on the garage floor. Bare concrete absorbs it, and freeze-thaw slowly flakes the surface.
Three things wear out Colorado garage floors, and a properly installed coating handles all three:
- 1
Freeze-thaw
Bare concrete is porous. Snowmelt soaks in, freezes overnight and expands, and over a few Frederick winters that pops the surface into scaling, pits and spalled edges by the door. - 2
Mag chloride & road deicer
Colorado roads are treated with magnesium chloride and other deicers. It rides home on your tires, drips off as the car warms up and keeps eating at a bare slab. On a sealed floor it stays on top, where it rinses off. - 3
Hot-tire pickup
Tires heat up on the highway. Park a hot tire on a thin, poorly bonded coating and it can soften and lift right off with the tire. Diamond-ground prep and a real topcoat are how we prevent it.
03What fits
The right system for Frederick floors.
We'll confirm the right one for your slab at the free on-site measure.
We price by the square foot, and you see the same ranges in Frederick that you'd see anywhere else we work. Here's a typical Frederick job using our current full-flake range:
2-car garage · 450 sq ft · Full-Flake
$2,813 – $2,925
Includes diamond-ground prep. Heavy crack repair or removing an old coating can add to it. Final price after a free on-site measure.
| System | Per sq ft | 2-car (450 sq ft) |
|---|---|---|
| Full-Flake$6.25–$6.50/sq ft | $2,813–$2,925 | |
| Solid Color$5.00–$6.00/sq ft | $2,250–$2,700 | |
| Quartz$7.00–$9.00/sq ft | $3,150–$4,050 | |
| Metallic$9.00–$12.00/sq ft | $4,050–$5,400 |
05Instant estimate
Frederick floor prices, instantly.
Pick your space and system and see a price range for your Frederick project now. Final price after a free on-site measure.
Your estimate · Full-Flake · 450 sq ft
Based on $6.25–$6.50 per sq ft.
Estimate only — final price after a free on-site measure.
06How it works
From our Fort Collins shop to your Frederick floor.
Frederick is about 40 to 50 minutes south of our Fort Collins shop on I-25. Call or use the instant estimate, and we'll set up a free on-site measure at a time that works for you.
- 1
Call or tap for a price
Call us or use the instant estimate. You get a real range up front.
- 2
Free on-site measure
We measure, check the slab for cracks and old coatings, and confirm your price.
- 3
Grind, repair, coat
Diamond-grind prep, crack repair, base coat, flake or finish, and a clear topcoat.
- 4
Pull back in
Once it's cured, park on a floor that cleans up with a mop and looks finished.
07Before & after
Same floor. Drag the line.
Real Iron Cross jobs, photographed before we started and after we finished. No filters, no renders.
BeforeAfter“These guys are awesome, came in, figured out what needed to be done, and knocked it out. I had a large crack on my floor, along with several smaller ones, and they are gone. The large one was 9 ft and going in several different directions, and it's gone. Great job guys!!”
- 5 out of 5 stars
“I had a great experience with Iron Cross Coatings from start to finish. The communication was clear, the prep work was done right, and the final result exceeded expectations. You can tell they take pride in their process — the floor looks clean, uniform, and professionally installed. They showed up on time, kept the workspace organized, and delivered exactly what was promised.”
Cisco Ortiz · Google
- 5 out of 5 stars
“Absolutely awesome!! Had some bad luck with my last contractor so we were a bit nervous to call but Chris went above and beyond to give us a great experience. Couldn't be happier!”
Kameron Banks · Google
- 5 out of 5 stars
“Top-notch epoxy garage floor service! CJ is a man of his word—professional, reliable, and delivers exactly what he promises. The quality of work is outstanding. Highly recommended!”
James N. · Google
- 5 out of 5 stars
“Thanks, CJ! I couldn't be happier with the results. Great communication and quality work. He made the whole process super smooth. I highly recommend his services.”
Jordan Wells · Google
- 5 out of 5 stars
“Super professional dude! Didn't hesitate to drop what he was doing and come give me an estimate. Easy guy to deal with. 10/10 would recommend!”
Michael Greatheart · Google
09FAQ
Frederick questions.
Don't see yours? Call and ask. That's what the phone's for.
How much does an epoxy garage floor cost in Frederick?
Our full-flake garage system runs about $6.25–$6.50 per sq ft. For example, a 2-car garage (about 450 sq ft) with full-flake lands around $2,813–$2,925. Slab repair can change that, so your final price comes after a free on-site measure.
Do you serve Frederick, Firestone and Dacono?
Yes. Frederick and Firestone are part of our regular area along I-25. Call 970-599-1898 or use the instant estimate to get started.
How do I pick a flake color?
Try the floor visualizer with a photo of your garage, then we bring real samples to your free measure so you can see them in your own light.
How far is Frederick from your shop?
Frederick is about 40 to 50 minutes south of our Fort Collins shop on I-25. Call 970-599-1898 and we'll set up a free on-site measure at a time that works for you; Saturdays are by appointment.
Every system we install in Frederick
10Service area
Fort Collins to Denver.
Based in Fort Collins (80525). We install across Northern Colorado and the Denver metro.
- Mon – Fri
- 7:30am – 5:00pm
- Saturday
- By appointment
- Sunday
- Closed
Northern Colorado
Free estimate
Frederick, let's
talk floors.
Fastest way to a price is a phone call. Rather type? Send the form and we will call you back.
Call 970-599-1898Mon–Fri 7:30am–5:00pm · Sat by appointment